For studying the semiconductor zone structure, the simulation of the conductivity processes and development of real semiconductor devices the knowledge of the effective mass of quasi-particles is necessary. Therefore, the problem of determining the e...
The production of ohmic contacts to heterobipolar nanostructures has a number of peculiarities. In addition to the basic requirement of minimizing the contact resistance, the contacts to this type of structures have a transient layer, the penetration...
To ensure the efficiency, durability and reliability of three-dimensional microelectronic modules the engineering calculation of structures, including modeling of the adhesive-bonded joints, the stipulated choice of materials and design solutions, is...
To calculate the nonlinearities, usually a commonly used histogram method is applied, in which the input sinusoidal signal has a range exceeding the full scale. But in some cases it is required to determine the characteristics of the analog-digital s...
With the reduction of the technological sizes of the transistors the influence of the circuit and process variations on the value of the element delays in the combinational circuits becomes significant. Due to variations of these parameters the uncer...
In micro-electromechanical systems the resonators are used in the construction of generators, sensors of inertial navigation systems, in RF transceivers, for increasing the sensitivity (acoustic, biological, mechanical, etc.). In this paper the chang...
Urrently, the sensors and actuators based on the MEMS products are increasingly used in a variety of applications. In the process of developing new products of the nano and microsystem equipment it is necessary to reliably determine the parameters of...
The high-sensitive biomarkers, developed based on the quantum dots (QD), present an alternative to widely known organic dyes, which are used during surgical operations on retina. The QD biological properties permit to distinctly visualize the state o...
The specifics of MANET (Mobile Ad-hoc Network) wireless decentralized self-organizing network, consisting of mobile nodes, is that each node of the network acts as a terminal device or as a router for transit traffic. The constant movement of the nod...
In many radiotechnical systems the microwave power amplifiers based on the monolithic integrated circuits, especially in the output power amplifiers (OPA) of transceiving modules AFAR, have become commonly used. It has been shown that selective distr...
Creation of the information-measuring system (IMS), in which the principle of multichannel processing is implemented, will allow using it as a local differential-distance system with an increased distance of detection, capable of determining current ...
Abrasive cutting is used in the manufacture of the semiconductor and dielectric substrates in solid state electronics. In the technological preparation for manufacturing the substrates the problem of selecting the most economically stipulated cutting...